Meet national standards such as YD/T2150-2010, GB/T2423-2008, GB/T3873-1998, GB/T9286-1998 and international standards such as IEC 61300-3-15, IEC 61300-3-16, IEC 61300-3-17, IEC 61300-3-23.

• High strength engineering plastic injection molding, good mechanical performance, elegant appearance, robustness and durability

• Suitable for indoor and outdoor, wall-mounted, pole, aerial installation

• Splitter Type: Insert splitter, 1:4, 1:8, 1:16, 1:32

• Turn-over structure, layout is reasonable, splicing zone below and distribution zone above

• Fibre route reasonable, fibre bending radius at any place is greater than 30mm

• The mark is clear on each fibre connection and distribution

• The box door opening Angle is greater than 120° for easy operation and maintainance

• The splice tray can be taken down and put on the bench for splicing, convenient operation

• The redundant fibre is wound and protected